TANKLESS WATER HEATER
Friday, July 16th, 2010 at
11:25 am
I TOOK OUT MY OLD HOT WATER TANK AND PUT IN A NEW TITAN SCR2 ELECTRONIC TANKLESS WATER HEATER I GOT OFF EBAY
Tagged with: diy • hot water • INSTALL • tankless • TITAN • water heater
Filed under: Tankless Gas Water Heater
Like this post? Subscribe to my RSS feed and get loads more!
I just bought a Titan SCR2 and will use your video as a guide…. Thanks
no prob… glad i can help
So are yo saving any money with the new system? How long did it take to install? Which one did you get as far as model number? It looks great.
did you put in a 120 or 220 unit?
great video,,,, I bought titan scr2 and i did everything ,, and works for 2 min and turn off ,,, i dont what is problem ,, u think I need that box
pulloff,,,,
220 unit
sorry about the time on getting back to you…i`m savng money with the unit when the girls don`t say in the shower for hours becouse the hot water don`t run out ..lol…..but if you put one in your home as long as you don`t have the hot water on. the only power from the unit is a LED light ..not like a tank heater that heats water all day…the titan scr2 220 volt unit took me one night to put in and i took my time doing it….thanks for commenting
i`ed get a 220 volt pullout..make sure you have 6 gage wire and a 60 amp braker…is the braker kicking off or the unit?if the unit is going off test the wire with a test light to see if it is 220 volts of power..if the wire is 220 volts on a test light the unit is bad..if the wire is not 220 volts its in your wire and or breaker..hope that helps
august 10 2009 STILL WORKING GREAT!!!
awesome video, I want a system like this so bad!
thanks !! you can do it
I just replaced my water heater with n SCR2 Titan Tanless water heater but mine is the model N64 and the wire is not #6 but #10 which is easier to work with and the breaker is a 30 not a 60. I am super Happy and I can honestly say that you doing yours and psting it here gave me the courage to do mine…… Thank You :^)
Well done.
no prob glad i could help : ^ )
thanks!!
December 21 2009 still working great!!
do you notice any drop in your electric bill?
5 of 5
What was your cost for parts, all together?
about $300
yes if i don`t use it alot
The ground wires and neutral wires were shared under the screw posts; Bad! You segregated them; Excellent!
The only reason it is OK to put ground wires and neutral wires on the same bus bar is because this is a service entrance. (Never do so on feeder, branch or sub panels.)
The only things omitted seem to be references to the required equipment grounding conductors in the non-fusible pull-out; and the lack of cable clamps on the same box.
60amp?? HOLY SHIT! my main is 100amp…
Nice work! I have a 64 gallon tub that never gets filled with hot water, as the tank runs out!!! Imma gonna get after this! Would you choose the same model and brand if you were to do it again?
Thanks!
you are a good plumber , electric needs improvement, you cannot have the black wire exposed like that ,you need to put it inside pvc pipe or something only for the exposed parts.very good everithing else.
There’s a coupon for $50 off any EcoSmart heater on
acehotline(dot)com
It’s their “end of the month sale”
The coupon code is: 15952
Just though I would pass the word around